Installation

  • All our products should be installed by a fully qualified plumber.

  • We recommend you use a high bonding silicon when mounting the bath.

  • Do not over tighten the waste as it may crack the base of the bath / basin / custom sink.

  • Contact us if advice is needed for installation or you are uncertain of any aspect of the fitting of the products.

  • All trades must have very clean hands or wear surgical gloves when handling your products.

  • They must not stand in the bath with work boots on

  • Before the first use, do not use any abrasives/Bam/Jiff etc or solvent like acetone to clean your product as it will remove the sealer and will damage the surface of your product. Simply clean it with soapy water and dry with a towel.

PLEASE FOLLOW THE STEPS BELOW TO SAFELY UNPACK YOUR BATH

  1. Your bath must be left in its crate until it is in its final location. Only then can the crate be removed.

  2. When ready to install the bath, cut the top part of the crate off using an electric saw. Do not use a hammer.

  3. Remove the top of the crate by lifting it straight up. Do not bend top of crate to the side as this may cause damage to the bath.

  4. Cut off the vertical wooden poles one by one until the bath is left bare sitting on the crate base.

  5. You can then gently slide the bath to the floor level, using a protection blanket if necessary. Make sure there are no protruding nails left on or around the crate base to avoid any scratch to the bath.

  6. Follow normal bath installation process from there on.